MTB
The model is designed for passionate off-road enthusiasts while remaining versatile and easy to use. Whether you have wide or narrow tyres, the PARKIS MTB will meet all your needs. It is made from anodised aluminium and galvanised painted steel. The package includes fastening screws and a user manual.
Buy 2-3 and get 5% off
Buy 4 or more and get 10% off
Every second lift delivery is free of charge
385.00
Specifications
Installation
Downloads
tyre width (A)
max. 77 mm (3.0”)
rim + tyre total height (B)
max. 86 mm (3.4”)
wheel diameter (minimum)
61 cm (24″)
bike weight
up to 30 kg (66 lb)
mud flap (fender) end (C; D)
must be above the wheel axis
No measurements for fixing points are required! Just lean your PARKIS to a wall and fasten it with four screws (included). It takes 1 minute of your precious time for a wooden wall and up to 5 minutes for a masonry wall.
Fitting accessories
Supplement for specific needs
Extension Bracket set
One set includes 2 units of extension brackets to install PARKIS against a wall with a skirting board (plinth). It contains all the required screws and an installation guide. This Bracket pulls PARKIS an additional 2,5 cm (0,98″) off the wall, so the floor skirting is not an obstacle. Made of stainless steel.
Volume discount available
Angle Extension set
The Angle Extension set accessory is designed to mount any PARKIS model to a wall at a 48-degree angle. This extension set enables cyclists to park their bicycles conveniently in different situations, particularly in narrow premises. The accessory is made of high-quality stainless steel and the set includes screws and a manual.
Volume discount available
Adjustable Mounting Extension set
The Adjustable Mounting Extension Set is designed to allow the installation of PARKIS bike lifts at a distance from a wall. That is necessary in extra space-saving mode, where several bike lifts can be installed incredibly close to each other (40 cm/ 16″ or less) or when the bike rack needs to be installed on a distant pillar.
Volume discount available
Mounting Extension + rear wheel support set
The Mounting Extension Set with rear wheel support is designed to allow the installation of PARKIS bike lifts at a distance from a wall. That is necessary in extra space-saving mode, where several bike lifts can be installed incredibly close to each other (40 cm/ 16″ or less) or when the bike rack needs to be installed on a distant pillar.
Volume discount available
Locking Loop
It is recommended that this accessory be installed on a floor or wall next to the PARKIS lift for bike locking purposes. It allows the bicycle to be locked by the frame. Made of stainless steel, it comes with an installation guide.
Volume discount available
Locking Gates 3,0″
The Locking Gates 3.0″ accessory enables the locking of a bicycle over a frame. It is recommended for use with PARKIS MTB or City models in public places. The accessory also protects the lift from bikes with tyres that are too thick. It is made of stainless steel.
Volume discount available
Rear Wheel Support
The Rear Wheel Support accessory is recommended for use when the PARKIS is installed away from a wall, such as when using the Mounting Extension accessory. Or to prevent the wall from getting dirty by stopping the bicycle tyre from leaning against it. Made of stainless steel, the accessory comes with an installation guide.
Volume discount available
Bicycle Frame Holder
Bicycle Frame Holder is an accessory made for manual bicycle frame fixation when PARKIS is installed inside a means of transportation (van, bus, train, etc.). It is recommended for long-distance bicycle transport.
Volume discount available